HP Pavilion Aero 13.3 Maintenance and Service Guide - Page 43
Remove the Phillips M2.0 × 2.5 screw
View all HP Pavilion Aero 13.3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
1. Remove the plastic that covers the antenna connectors (1). 2. Carefully disconnect the antenna cables from the module (2). 3. Remove the Phillips M2.0 × 2.5 screw (3), and then remove the WLAN module (4). NOTE: Models have either one or two WLAN antennas. On models with two antennas, the #1 white WLAN antenna cable connects to the WLAN module #1 Main terminal. The #2 black WLAN antenna cable connects to the WLAN module #1 Aux terminal. 4. If the WLAN antenna is not connected to the terminal on the WLAN module, you must install a protective sleeve on the antenna connector, as shown in the following illustration. Reverse this procedure to install the WLAN module. Component replacement procedures 35
1.
Remove the plastic that covers the antenna connectors
(1)
.
2.
Carefully disconnect the antenna cables from the module
(2)
.
3.
Remove the Phillips M2.0 × 2.5 screw
(3)
, and then remove the WLAN module
(4)
.
NOTE:
Models have either one or two WLAN antennas. On models with two antennas, the #1 white
WLAN antenna cable connects to the WLAN module #1 Main terminal. The #2 black WLAN antenna cable
connects to the WLAN module #1 Aux terminal.
4.
If the WLAN antenna is not connected to the terminal on the WLAN module, you must install a protective
sleeve on the antenna connector, as shown in the following illustration.
Reverse this procedure to install the WLAN module.
Component replacement procedures
35