HP ProBook 4520s HP ProBook 4520s Notebook PC and HP ProBook 4720s Notebook PC - Page 112
When replacing the system board, be sure that the following components are removed from
View all HP ProBook 4520s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 112 highlights
When replacing the system board, be sure that the following components are removed from the defective system board and installed on the replacement system board: ● Memory module (see Memory module on page 55) ● WLAN module (see WLAN module on page 65) ● WWAN module (see WWAN module on page 68) ● Modem module (see Modem module on page 99) ● Processor (see Processor on page 74) ● Audio board (see Audio board on page 101) Remove the system board: 1. Position the computer right-side up with the front toward you. 2. Remove the M2.0x3.0 screw on the left of the system board (1). 3. If this is a 17.3-in computer, remove the single M2.0 x 3.0 screw (2) that secures the optical drive connector to the base. NOTE: The 15.6-in computer does not use a separate optical drive connector. 4. Lift the board at an angle (3) and remove the optical drive extender (4). 5. Slide the board partially out of the base pan (5). 104 Chapter 4 Removal and replacement procedures