HP ProLiant 4500 Compaq ProLiant 4500 Servers Maintenance and Service Guide - Page 41
Configuration Utility
View all HP ProLiant 4500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
3-8 Diagnostic Tools POST Error Messages Continued Error Code Beeps Probable Source of Problem 1761-Fixed Disk 1 does not support Block Mode None Fixed disk drive error. 1771-Primary Disk Port Address Assignment Conflict None Internal and external hard drive controllers are both assigned to the primary address. 1772-Secondary Disk Port Address Assignment Conflict None Address Assignment Conflict. Internal and external hard drive controllers are both assigned to the secondary address. 1773-Primary Fixed Disk Port Assignment Conflict None Fixed disk drive error. 1776-Drive Array SCSI Port Termination Error None External and internal SCSI drives are both configured to Port 1. 1777-Drive Array Error None Cooling fan failure, internal temperature alert or open cover. 1778-Drive Array resuming Automatic Data Recovery process None This message appears whenever a controller reset or power cycle occurs while Automatic Data Recovery is in progress. 1779-Drive Array Controller detects replacement drives None Intermittent drive failure and/or possible loss of data. Action Run the System Configuration Utility and correct. Run the System Configuration Utility and correct. Run the System Configuration Utility and correct. Run the System Configuration Utility and correct. Re-configure drives. Inspect for cooling fan failure or open cover. No action necessary. If this message appears and drive X has not been replaced, this indicates an intermittent drive failure. This message also appears once immediately following drive replacement whenever data must be restored from backup. Continued Maintenance and Service Guide