HP Rp3000 Hardware Reference Guide - HP rp3000 - Page 18
Removing or Installing an Expansion Card, Installing and Removing a PCI Card or PCI Express x1 Card
UPC - 884420494096
View all HP Rp3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Removing or Installing an Expansion Card The computer has either a full-height PCI expansion slot (1) or a full-height PCI Express x1 expansion slot (2), depending on the model. NOTE: The maximum length supported for a PCI card or a PCI Express x1 card is 16.76 cm (6.6 inches). Figure 2-8 Expansion Slot Locations Installing and Removing a PCI Card or PCI Express x1 Card You can install one full-height PCI expansion card or one full-height PCI Express x1 expansion card, depending on the model. To install an expansion card: 1. Remove/disengage any security devices that prohibit opening the computer. 2. Remove all removable media, such as compact discs, from the computer. 3. Turn off the computer properly through the operating system, then turn off any external devices. 4. Disconnect the power cord from the power outlet and disconnect any external devices. CAUTION: Regardless of the power-on state, voltage is always present on the system board as long as the system is plugged into an active AC outlet. You must disconnect the power cord to avoid damage to the internal components of the computer. 5. Remove the computer cover. 12 Chapter 2 Hardware Upgrades ENWW