HP Rp3000 Hardware Reference Guide - HP rp3000 - Page 21
Replacing the Expansion Card Retainer Screw, Computer Setup F10 Utility Guide
UPC - 884420494096
View all HP Rp3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
10. To install a new expansion card, align the bracket on the expansion card with the open slot on the rear of the chassis and press the card straight into the expansion socket. Figure 2-12 Installing an Expansion Card NOTE: When installing an expansion card, press firmly on the card so that the whole connector seats properly in the expansion card slot. 11. Replace the screw that secures the expansion card or expansion slot cover. Figure 2-13 Replacing the Expansion Card Retainer Screw 12. Connect external cables to the installed card, if needed. Connect internal cables to the system board, if needed. 13. Replace the computer cover. 14. Reconnect the power cord and any external devices, then turn on the computer. 15. Lock any security devices that were disengaged when the computer cover was removed. 16. Reconfigure the computer, if necessary. Refer to the Computer Setup (F10) Utility Guide on the Documentation and Diagnostics DVD for instructions about using Computer Setup. ENWW Removing or Installing an Expansion Card 15