Hitachi DS10DFL Service Manual - Page 20

6. Reassembling of the housing (1) Attach the LED to Housing (A). (B)Set [29]. When attaching the LED, be careful to prevent not to twist the LED wire (delivered as an accessory for DC-Speed Control Switch [35]). Also be sure to run the LED wire through the fixing rib on the housing. (See the figure below.) (2) Motor DC12V [28] and Gear Box Ass'y [3] (already coupled) and Shift Knob [33] in Housing (A). (B)Set [29]. When mounting these parts, the convex features of Gear Case [9] and Motor Spacer [27] must be fitted into the corresponding concave features of Housing (A). (B)Set [29]; the convex feature of Clutch Dial [4] must be fitted into the corresponding concave feature of Housing (A). (B)Set [29]. Also, the two Needles [16] projecting from Gear Case [9] must be fitted into the two holes on Housing (A). (B)Set [29]. Be careful to prevent the LED wire from being caught between the housing and mounted parts. (See the figure below.) x Reassembling of the housing (1) Housing (A). (B)Set [29] (A) Part to mount Motor Spacer [27] Parts to mount Gear Case [9] Parts to mount Needles [16] Rib to fix the LED wire Part to mount Clutch Dial [4] LED LED mounting space -17-