Honeywell HPF24S6 Installation Manual - Page 12

System Overview Specifications Power-limited (Class 2), Supervised, Special Application or Regulated Nonpower-limited To Transformer #1 To Transformer #2 Supervised, Nonpower-limited Earth AC Neutral AC Hot NAC/Out 1 + NAC/Out 1 NAC/Out 2 + NAC/Out 2 NAC/Out 3 + NAC/Out 3 NAC/Out 4 + NAC/Out 4 - EARTH NEUT HOT TB1 OUT4 - NAC4 + 8 7 OUT3 - NAC3 + 6 5 OUT2 - NAC2 + 4 3 OUT1 - NAC1 + 2 1 TB2 AUX TBL NO NC COM TB5 3 2 1 Trouble Relay Form-C Fail-safe Nonsupervised (shown energized) Normally Open Normally Closed Common TRANSFORMER 2 TRANSFORMER 1 JP1 Ground Fault Detection J2 (cut to disable) JP1 J3 J3 JP2 ZNAC-4 Connector JP2 & JP3 JP3 Coded/Noncoded J1 Input Selection Auxiliary Output 500 mA Special AUX - 10 Application Power* AUX + 9 IN2- 8 IN2+ 7 OUT1- 6 OUT1+ 5 IN1- 4 F1 IN1+ 3 - + JP4 BATTERY AC GND FLT NAC AC/ BATT TRBL CHGR ON SW1 1 2 3 4 5 6 7 8 SYNC IN - 2 SYNC IN + 1 TB4 JP4 Supervised + Battery - Battery 18 AH, 24 VDC Nonpower- F1 limited Battery Fuse 15A, 32V (Canadian version is nonreplaceable 12 A, 32V) SW1 LEDs Programming Charger Trouble/AC Loss (yellow) DIP Switches NAC Trouble (yellow) (change switch settings only Battery Trouble (yellow) when all power Ground Fault (yellow) (AC & DC) is AC Power (green) removed) Figure 1.1 HPF24S Board Layout - Aux. Common + Aux. 24 VDC* - Control Input 2 + Control Input 2 - Out Common + Out/Trouble Contact - Control Input 1 + Control Input 1 - Sync Input + Sync Input *Note: Auxiliary Power Output is power-limited (Class 2) but not supervised 24fs8brd.wmf 12 HPF24S Series Power Supplies - P/N 52751:F2 7/11/2014