Honeywell HPF24S6 Installation Manual - Page 36

Applications Master HPF24S Power Supply Connected to FACP 5.6 Master HPF24S Power Supply Connected to FACP In this application, a master HPF24S power supply, set for synchronization, is connected to an FACP with nonsynchronized output. Standby Polarity Shown FACP NAC with no syncronization - NAC1 + Internal Trouble Contact HPF24S 1 2 3 4 5 6 7 8 9 10 ELR for FACP NAC OUT4 OUT3 OUT2 OUT1 -NAC4+ -NAC3+ -NAC2+ -NAC1+ TB2 AUX TBL NO NC COM TB5 JP1 J3 JP2 JP3 AUX AUX + IN2IN2+ OUT1OUT1+ IN1IN1+ SYNC IN SYNC IN + TB4 8 7 6 5 4 3 2 1 3 2 1 24fsapp11b.wmf SW1 Switch Settings 1 & 2 = sync (any setting but OFF/OFF) 3 = OFF (master) 4 = OFF (No AC Fail Reporting Delay) 5 = 6 = OFF OFF general alarm 7 = OFF (charger enabled) 8 = OFF (circuit 4 NAC) Figure 5.6 Supervised FACP to Master Connections (nonsynchronized source) The following notes apply to this illustration 1. Refer to NFPA 72, Chapter 4-4, Visible Characteristics, Public Mode. 2. Use only devices from the same manufacturer in each system. 5.7 Canadian Applications NOTE: Mass Notification is not for use in Canadian applications. Canadian applications, per ULC, require the following: • The HPF24S power supply must be used as a Notification Appliance Circuit extender only. The TB2 terminals cannot be configured as auxiliary power outputs. • The host FACP must monitor for all ground fault conditions. The Ground Fault Detection circuit on the HPF24S power supply must be disabled by cutting jumper JP1. • The negative (-) battery terminal of the HPF24S power supply must be connected to the negative (-) battery terminal of the host FACP. 36 HPF24S Series Power Supplies - P/N 52751:F2 7/11/2014