Honeywell HPF24S6 Installation Manual - Page 35
Master FACP with Slave HPF24S Power Supply, Supervised Master/Slave Connections
View all Honeywell HPF24S6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Master FACP with Slave HPF24S Power Supply Applications 5.5 Master FACP with Slave HPF24S Power Supply In this application, an HPF24S power supply, configured as a Slave unit, is connected to a master FACP programmed for synchronized output. The power supply should be set for synchronization which matches the FACP programming. Standby Polarity Shown FACP See Note 3 - NAC1 (programmed for sync) + Internal Trouble Contact HPF24S 1 2 3 4 5 6 7 8 9 10 ELR OUT4 OUT3 OUT2 OUT1 -NAC4+ -NAC3+ -NAC2+ -NAC1+ TB2 AUX TBL NO NC COM TB5 JP1 J3 JP2 JP3 AUX AUX + IN2IN2+ OUT1OUT1+ IN1IN1+ SYNC IN SYNC IN + TB4 SW1 Switch Settings 1 & 2 = sync (any setting 8 but OFF/OFF) 7 6 3 = ON (slave) 5 4 4 = OFF (no AC Fail 3 2 reporting delay) 1 3 5 6 = = OFF OFF general alarm 2 1 7 = OFF (charger enabled) 8 = OFF (circuit 4 NAC) 24fsapp1c.wmf Figure 5.5a: Supervised Master/Slave Connections (Filtered, Synchronized NAC Source) Standby Polarity Shown FACP - Remote Sync Output + OUT4 OUT3 OUT2 OUT1 -NAC4+ -NAC3+ -NAC2+ -NAC1+ TB2 AUX TBL NO NC COM TB5 JP1 J3 JP2 JP3 AUX AUX + IN2IN2+ OUT1OUT1+ IN1IN1+ SYNC IN SYNC IN + TB4 Internal Trouble Contact 1 2 3 4 5 6 7 8 9 10 ELR SW1 Switch Settings 1 & 2 = sync (any setting 8 7 but OFF/OFF) 6 5 3 = ON (slave) 4 3 4 = OFF (no AC Fail 2 reporting delay) 1 5 = OFF 3 2 6 = OFF 1 7 = OFF (charger enabled) 8 = OFF (circuit 4 NAC) 24fsapp1b.wmf Figure 5.5b: Supervised Master/Slave Connections (Remote Sync Source) Figure 5.5 Supervised Master/Slave Connections The following notes apply to both illustrations in Figure 5.5 on page 35 1. Refer to NFPA 72, Chapter 4-4, Visible Characteristics, Public Mode. 2. Use only devices from the same manufacturer in each system. 3. If the FACP has a dedicated sync output connector, wire the remote sync output connector to the HPF24S Sync In terminals TB4 terminals 1 & 2. Refer to the Supervised Master/Slave Connections (Remote Sync Source) in Figure 5.5b. HPF24S Series Power Supplies - P/N 52751:F2 7/11/2014 35