Honeywell HPF24S6 Installation Manual - Page 34
Remote Power Supply Application, HPP Device Compatibility Document #54399
View all Honeywell HPF24S6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Applications Remote Supply With Resettable and Nonresettable Power For addressable panel applications, an addressable monitor module can be used to monitor the trouble contact of the HPF24S and the resettable power connection from the FACP using an End-ofLine power supervision relay. If the HPF24S enters a trouble condition, the Normally Closed trouble contact will open and if the resettable power from the FACP is lost, the Normally Closed power supervision relay contact will open. HPF24S 24 VDC Resettable Power FACP Power Output 4 Nonresettable Power Output 3 Nonresettable Power Output 2 Resettable Power Output 1 Resettable T11 T10 T9 T8 T7 T6 SLC T1 T2 T3 T4 T5 End-of-Line Resistor supplied with Monitor Module SW1 Switch Settings 1 = OFF 2 = OFF No Sync 3 = OFF (master) 4 = ON (Aux Trouble Relay responds to all troubles) 5 6 = = OFF ON Split Alarm 7 = OFF (charger enabled) 8 = OFF (circuit 4 NAC) EOL Power Supervision Relay EOLR-1 (energized) Monitor Module* *If the SLC device does not match the one in this figure, refer to the SLC SLC manual wiring conversion charts for legacy and newer versions of the modules. 24fsapp4tpH.wmf Figure 5.4 Remote Power Supply Application The following notes apply to Figure 5.4 on page 34. 1. An End-of-Line Resistor must be installed between TB5, Terminal 1 (trouble relay common) and the monitor module input circuit for module wiring supervision (the ELR value is dependent on the module employed). 2. An End-of-Line power supervision relay must be connected between TB4, Terminals 5 & 6. The Normally Closed (when energized) power supervision relay contact must be in series with the End-of-Line Resistor referred to in note 1. 3. Do not loop wires under screw terminals. Break wires to maintain proper supervision. 4. For a list of compatible devices, refer to the HPP Device Compatibility Document #54399. 34 HPF24S Series Power Supplies - P/N 52751:F2 7/11/2014