Husqvarna L 221AK Owner Manual - Page 23
Maintenance, PrÉsentation - drive belt
View all Husqvarna L 221AK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
PRÉSENTATION Responsabilités du client • Lire et observer toutes les règles de sécurité. • Suivre le programme d'entretien fourni dans ce manuel. Toute opération d'entretien autre que celles décrites dans ce manuel doit être effectuée par le distributeur (détaillant). La tondeuse Numéro de série : Date d'achat : Le modèle et les numéros de série sont indiqués sur un autocollant apposé à l'arrière du carter de la tondeuse. Vous devriez enregistrer à la fois le numéro de série et la date d'achat et les conserver en lieu sûr pour référence future. Caractéristiques du produit Contenance et type d'essence 0,98 l (ordinaire sans plomb seulement) Type d'huile (API SG-SL) SAE 30 (au-dessus de 0 °C) SAE 5W-30 (au-dessous de 0 °C) Capacité d'huile 473 ml Bougies (écartement : 0,75 mm) Couple de serrage du boulon de lame BPR5ES 47 à 54 N.m MAINTENANCE Assembly: 1 Position the blade adapter on the engine crank shaft. Be sure key in adapter and crankshaft keyway are aligned and that the drive belt is inside the tab of the belt retainer. 2 The blade must be mounted with the angled ends pointing up towards the engine. 6 Verify the spark plug wire is disconnected from the engine. ! WARNING! Always disconnect spark plug wire and place wire where it cannot contact spark plug to prevent accidental starting. 7 Pull the blade around by hand and make sure it rotates freely. 3 Install the blade bolt with the lock washer and hardened washer into blade adapter and crankshaft. IMPORTANT! Always exercise care and use your common sense. Avoid all situations which you consider to be beyond your capability. If you still feel uncertain about operating procedures after reading these instructions, you should consult an expert before continuing. Contact an authorized service workshop. Always use genuine parts. 4 Use block of wood between blade and lawn mower housing and tighten the blade bolt, turning clockwise. 58 - French 5 The bolt should be tightened with a torque of 35-40 ft. Ibs. / 47-54 Nm. English - 23