Husqvarna L 221AK Owner Manual - Page 25
Maintenance, Explication Des Symboles
View all Husqvarna L 221AK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
EXPLICATION DES SYMBOLES Explication des symboles AVERTISSEMENT! La machine peut être un outil dangereux si elle est mal utilisée ou négligée, ce qui peut provoquer des blessures graves ou mortelles à l'opérateur ou d'autres personnes. Lire attentivement le manuel d'utilisation et veiller à bien comprendre les instructions avant d'utiliser la scie. Couper le moteur Avertissement : découpeuse rotative. Garder les mains et les pieds à l'écart. Avertissement : pièces rotatives. Garder les mains et les pieds à l'écart. Tenir les personnes et les animaux à l'écart de la zone de travail. Démarrer le moteur ASRTROÊPT Avant de reculer, regarder derrière et vers le bas pour vérifier la présence éventuelle de petits enfants, d'animaux ou autres risques de chute. Risques liés aux travaux sur les pentes. Rapide Lent Carburant Huile Volet de départ DANGER Garder les mains et les pieds à l'écart Faire attention aux objets projetés et aux ricochets. Utiliser un dispositif de protection homologué pour les oreilles. Explication des niveaux d'avertissement Les avertissements sont classés en trois niveaux. AVERTISSEMENT! ! AVERTISSEMENT! Utilisé en cas de risque de blessure grave ou de décès de l'utilisateur ou de dommages à l'environnement si les instructions du manuel ne sont pas suivies. IMPORTANT! ! IMPORTANT! Utilisé en cas de risque de blessure de l'utilisateur ou de dommages à l'environnement si les instructions du manuel ne sont pas suivies. MISE EN GARDE! MISE EN GARDE! Utilisé en cas de risque de dommages à la machine si les instructions du manuel ne sont pas suivies. 56 - French MAINTENANCE • Remove the blade bolt by turning the bolt counter- • Remove all 3 idler pulleys from idler assembly. clockwise. Remove blade and attaching hardware: bolt, lock washer and hardened washer. • Remove the Mulching plug. • Remove belt from blade adapter / engine pulley and idler assembly. • Remove rear insert. • Remove the belt cover and the stripper ring. • Disconnect cable from rear transmission. • Remove front belt keeper. • Remove belt from front transmission pulley. • Remove rear transmission pulley by clamping locking pilers to the input shaft of the transmission, beneath pulley, and loosen the pulley with a 9/16" box wrench. • Remove the old drive belt. Replace the drive belt. IMPORTANT! Always use genuine parts. • Place new belt on rear transmission pulley. Be sure the new belt is inside the tabs of the belt keeper. • Reinstall rear transmission pulley. Route the other end of the new belt through hole in housing to front transmission pulley. Route new belt through idler assembly to blade adapter / engine pulley. • Reinstall all 3 idler pulleys. • Position the blade adapter / engine pulley on the engine crank shaft. Be sure key in blade adapter / engine pulley and crankshaft keyway are aligned and that the new belt is inside the tab of the belt retainer. Install new belt on front transmission pulley. • Reinstall front belt keeper. Make sure the new belt is inside the front belt keeper. • Reinstall drive cover. • Reattach cable to rear transmission and reattach return spring to rear insert / rear transmission belt keeper. • Reinstall rear insert. • Reinstall the blade. See instructions in the section "Replacing the blades". • Tighten spark plug. English - 25