Icom IC-SAT100M Operating Manual - Page 13
Connecting And Maintenance
View all Icom IC-SAT100M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
5 CONNECTING AND MAINTENANCE Rear panel connection 1 2 Optional speaker 5 RRWARNING! NEVER remove the fuse holders from the DC power cable. Red: +, 3 Black: _ NOTE: Use the terminals as shown below for the cable connections. Crimp Solder 4 4 Fuse holders 12 V or 24 V Battery 1 EXTERNAL SPEAKER JACK Connect a 4 Ω external speaker. 2 IGNITION LEAD Connect to an ignition line. CAUTION: DO NOT put pressure on this lead. Binding to the DC power cable is recommended. 3 DC POWER CONNECTOR Connect to a 12 V/24 V DC battery. Pay attention to polarities. Red line: +, Black line: _ LLYou can also connect the optional AC adapter. CAUTION: DO NOT reverse the DC power cable polarity when connecting to a power source. This could damage the transceiver. 4 LAN CABLE (Gray: for antenna, Black: for IP Network) Connect the supplied antenna or network devices such as a HUB. LLExternal power supply output (Gray LAN Cable) PoE output voltage: 54V PoE output current: 0.6A CAUTION: DO NOT connect other than network devices, such as microphone. This could damage the transceiver. 5 D-Sub 25-pin Connect to use the function extension. Ask your dealer for details. 10