Icom IC-SAT100M Operating Manual - Page 17
Connect the antenna unit and the LAN cable
View all Icom IC-SAT100M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
5 CONNECTING AND MAINTENANCE DDConnect the antenna unit and the LAN cable ••Connect the main unit and the supplied LAN cable (Length: approximately 20 m) as describe below. LLThe supplied LAN cable is a Shielded Ethernet Cable, so that use the supplied cable to connect the units. CAUTION: Be sure to ground the antenna unit . Otherwise, the antenna circuit may be damaged by a lightning strike or static electricity. Also, interference, RF feedback, and electrical shocks from other equipment could occur. ••You can also use a user supplied LAN cable (Category 5e or higher) up to 100 m. ••In addition to the grounding cable, using a lightning protection device (user supplied) for the LAN cable is recommended. 1. Remove the cover attached to the LAN cable. 2. Insert it into the antenna cable. 4. Connect to the gray LAN cable with the main unit. Supplied LAN cable Gray LAN cable of the main unit LAN cable with antenna unit Supplied LAN cable 3. Attach the cover attached to the LAN cable as shown. LLAfter connecting the Antenna cable and the LAN cable, wrap the connectors with rubber vulcanizing tape to help in waterproofing. LL Informatio When the transceiver is connected to network devices, change the static IP address. Before using the transceiver, enter a static IP address for the antenna unit and the main unit. Ask your dealer for details. Default IP address: 192.168.0.1 (Main unit ) 192.168.0.2 (Antenna unit) Subnet Mask: 255.255.255.0 Default Gateway: 192.168.0.254 14