Icom IC-SAT100M Operating Manual - Page 24

7 TROUBLESHOOTING Troubleshooting PROBLEM POSSIBLE CAUSE No power comes ON ••Bad connection to the power supply. ••Fuse is blown. "Antenna Unit No ••The serial numbers of the antenna unit Detect" is displayed. and the main unit are different. SOLUTION ••Check the connection to the transceiver and power supply. ••Find the cause, repair, and then replace the fuse. ••Connect the transceiver and antenna with the same serial number. REF. p. 10 p. 11 - Little or no sound comes from the speaker. You cannot transmit. No reply is received. You cannot use the keypad. No beep sounds. Failed to pair your Bluetooth headset ••Volume level is set too low. ••Rotate [DIAL] to adjust the volume p. 1 ••Does not connect to the microphone or level. the external speaker. ••An obstacle may exist between the ••Retry transmitting in a place without satellite and transceiver. obstacles. ••"Waiting for Registration..." is displayed. ••Wait until "IDLE" is displayed. ••The talkgroup is not correct. ••Confirm the talkgroup. p. 6 ••The operator is away from the ••Wait until the operator is back, or ask transceiver, or the transceiver is turned your system manager. OFF. ••The Key Lock function is ON. ••Push [P2] until "Lock OFF" is p. 4 displayed to turn OFF the function. ••The Key beep is set to OFF. ••Adjust the key beep level in the Menu p. 9 screen. ••The audio output level is low. ([OK] > Beep > Key Beep Lv) ••Rotate [VOL] to adjust the audio output level. ••The Bluetooth headset is not in the ••Confirm the Bluetooth headset is in Pairing mode. the Pairing mode, and then try again. ••There are other active Bluetooth devices ••Stop using other Bluetooth devices. nearby. ••Use the transceiver away from other ••There are other devices that are Bluetooth devices. operating in the 2.4 GHz band. ••Use the transceiver away from the other devices, or stop using those devices. p. 1 p. 18 21