Intel SBT2 Product Guide - Page 69

Password Jumper, See General Procedure to Change Jumper Setting

Get Intel SBT2 - SS3LE DUAL SLOT2 UPTO 4GB EATX PDF manuals and user guides
UPC - 735858140096
View all Intel SBT2 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 69 highlights

Password Jumper The jumper at pins 3-4 control whether the user and supervisor passwords are retained or cleared during a system reset. Procedure to clear the current password and then enter a new one: 1. See "General Procedure to Change Jumper Setting" on page 68. 2. Install a jumper on pins 3-4. 3. Reinstall the side cover for your safety, and connect the power cord to the system. 4. Turn the system on, and wait for POST to complete. This automatically clears the password. 5. Turn off the system, and disconnect the power cord. 6. Remove the side cover. 7. Remove the jumper from pins 3 and 4. 8. Reinstall the side cover, and connect the power cord to the system. 9. Run Setup to specify a new password. See Chapter 3. SBT2 Server Board Product Guide 69

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
SBT2 Server Board Product Guide
69
Password Jumper
The jumper at pins 3-4 control whether the user and supervisor passwords are retained or cleared
during a system reset.
Procedure to clear the current password and then enter a new one:
1.
See “General Procedure to Change Jumper Setting” on page 68.
2.
Install a jumper on pins 3-4.
3.
Reinstall the side cover for your safety, and connect the power cord to the system.
4.
Turn the system on, and wait for POST to complete.
This automatically clears the password.
5.
Turn off the system, and disconnect the power cord.
6.
Remove the side cover.
7.
Remove the jumper from pins 3 and 4.
8.
Reinstall the side cover, and connect the power cord to the system.
9.
Run Setup to specify a new password.
See Chapter 3.