JVC GY-HD250U 117 page operator's manual for the GY-HD250U - Page 103

e_hd250.book Page 99 Tuesday, October 24, 2006 3:11 PM GENLOCK Menu Screen Item SD H PHASE*1 HD H PHASE Function/Setting (bold characters indicate initial settings) Adjusts the horizontal (H) phase of the SD signal of this device according to the BB (Black Burst) signal input to the [GENLOCK IN] terminal. Increase the number : Proceed horizontal phase. Decrease the number : Delay horizontal phase. [Settings: MIN, −31 to −1, 0, 1 to 86, MAX] Adjusts the horizontal (H) phase of the HD signal and HD/SD SDI signal of this device according to the HD Tri-sync signal input to the [GENLOCK IN] terminal. In addition, during Tri-sync signal input, H PHASE of SD analog signals are simultaneously adjusted in HD H PHASE item. Increase the number : Proceed horizontal phase. Decrease the number : Delay horizontal phase. [Settings: MIN, −1023 to −1, 0, 1 to 1022, MAX] MEMO When adjusting the HD H PHASE, the setting value quickly changes while the USER1 or USER2 button is held down for approximately two seconds. SC COARSE*1 SC FINE*1 Adjusts the phase of the subcarrier (SC) of the composite or YC separate signal of this device according to the BB (Black Burst) signal input to the [GENLOCK IN] terminal. Increase the number : Proceed phase. Decrease the number : Delay phase. [Settings: 0°, 90°, 180°, 270°] Fine-tunes the phase of the subcarrier (SC) of the composite or YC separate signal of this device according to the BB (Black Burst) signal input to the [GENLOCK IN] terminal. Increase the number : Proceed phase. Decrease the number : Delay phase. [Settings: MIN, −127 to −1, 0, 1 to 126, MAX] PAGE BACK When the cursor is in this position, press the SHUTTER dial once to return to the OTHERS[1/2] menu screen. *1 REMOTE appears as the setting value of this item when the remote control unit is connected. • The setting value quickly changes while the USER1 or USER2 button is held down for approximately two seconds. 99