JVC KY-F550U Instruction Manual - Page 31

White Spot Correction (continued) Ⅵ White Spots Correction Messages Detecting Screen Detection Completed Screen PIXEL COMPEN EXECUT I NG PIXEL COMPEN OK TURN POWER OFF AND ON AGAIN. Detection Error Screen PIXEL COMPEN ERROR : LENS NOT CLOSED? PIXEL COMPEN ERROR : COUNT OVER TURN POWER OFF AND ON AGAIN. Notes ● The white spot correction feature of this unit does not correct all white spots. Detection and correction of white spots by this unit is performed under the following conditions. White spot correction will not be performed under conditions beyond those stated. In cases where conditions are fulfilled, correction may not be successfully performed depending on the nature of the white spots. In such case, perform the detection again until white spots are detected. Consult your JVC authorized dealer if white spots cannot be corrected. Quantity of Detection/Correction: 32 or less ● The screen on the right may be displayed during detection of white spots in cases when light enters the CCD during detection or depending on the PIXEL COMPEN ERROR : LENS NOT CLOSED? condition of white spots. In this case, check if there is light entering the CCD. ● During white spot correction, pixel data is obtained via interpolation of pixel information from the surroundings. Thus data may not be accurate for fine images. ● Results of white spot detection will be stored until the next detection is performed. ● During white spot detection, operation via the remote control will be disabled. PIXEL COMPEN ERROR : COUNT OVER TURN POWER OFF AND ON AGAIN. 29