Kenmore 7754 Use and Care Guide - Page 14

Kenmore 7754 - Elite 30 in. Gas Range Manual

Page 14 highlights

Warmer • • Drawer Removal Preparing Bread Dough for the Warmer Drawer Removing & Replacing Warmer Drawer Preparing Bread Dough for the Warmer Drawer The Warmer Drawer has a "Proof Bread" feature that can be used to help prepare bread dough. The recommended length of time to keep the bread dough in the Warmer Drawer is about 45-60 minutes, Be sure however to follow the recipe's recommended times, The prepared bread dough should be placed in a large bowl because the dough will nearly double in volume. Arrange the Warmer Drawer Rack in the downward position (See Fig. 1). Place the bowl on the rack in the Warmer Drawer and follow the Warmer Drawer and Bread Proof Control setting instructions at the top of this page, Fig.l Rack in downward position To Remove and Replace Warmer Pull up with finger (Warm & Ready TM) Drawer Drawer: To Remove Warmer 1. 2. 3. Left Glide 4. _ Turn poweroffbeforeremovingthewarmerdrawer. Open the drawer to the fully opened position. Locate glide lever on each side of drawer, pull up on the left glide lever and push down on the right glide lever (See Fig.2). Pull the drawer away from the range, (Warm & Ready TM) To Replace Warmer 1. 2. 3. Right Glide Drawer: [] Pull the bearing glides to the front of the chassis glide (See Fig. 3). Align the glide on each side of the drawer with the glide slots on the range. Push the drawer into the range until levers "click" (approximately 2"). Pull the drawer open again to seat bearing glides into position. If you do not hear the levers "click" or the bearing glides do not feel seated remove the drawer and repeat steps 1 thru 3. This will minimize possible damage to the bearing glides. Push down with finger Fig. 2 NOTE: The Warmer Drawer will NOT operate while in the Self-Clean and "Oven Lockout" modes Electrical Shock Hazard can occur and result GlAde n serious injury or death. Disconnect appliance from electric power before cleaning and servicing the Warmer Drawer, Fig. 3 14

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44

Warmer
Drawer
Removal
Preparing
Bread Dough for the Warmer
Drawer
Removing & Replacing Warmer
Drawer
Preparing
Bread
Dough
for
the
Warmer
Drawer
The Warmer
Drawer
has a "Proof Bread" feature
that can be used to help
prepare bread dough. The recommended
length of time to keep the bread
dough in the Warmer
Drawer is about 45-60 minutes,
Be sure however
to
follow the recipe's recommended
times,
The prepared
bread dough should be placed in a large bowl because
the
dough will nearly double
in volume. Arrange
the Warmer
Drawer Rack in
the downward
position
(See Fig. 1). Place the bowl on the rack in the
Warmer
Drawer and follow the Warmer
Drawer and Bread Proof Control
setting
instructions
at the top of this page,
Rack in downward
position
Fig.l
To Remove
and
Replace
Warmer
(Warm
& Ready
TM)
Drawer
Left
Glide
Pull up with
finger
To Remove
Warmer
Drawer:
1.
_
Turn poweroffbeforeremovingthewarmerdrawer.
2.
Open the drawer to the fully opened
position.
3.
Locate glide lever on each side of drawer,
pull up on the left glide lever and
push down on the right glide lever (See Fig.2).
4.
Pull the drawer away from the range,
Push
down
with
finger
Right
Glide
[]
Fig. 2
To
Replace
Warmer
(Warm
& Ready
TM)
Drawer:
1.
Pull
the
bearing
glides
to the front
of the chassis
glide (See Fig. 3).
2.
Align the glide on each side of the drawer with the glide slots on the range.
3.
Push the drawer into the range until levers "click" (approximately
2"). Pull
the drawer open again to seat bearing
glides into position.
If you
do not
hear
the levers
"click"
or the bearing
glides
do
not feel seated
remove
the drawer
and
repeat
steps
1 thru
3.
This will minimize
possible
damage
to the bearing
glides.
NOTE: The Warmer
Drawer will NOT operate while in the Self-Clean
and "Oven
Lockout" modes
GlAde
Electrical
Shock
Hazard can occur and result
n serious
injury or death. Disconnect
appliance
from electric
power before cleaning and servicing the Warmer
Drawer,
Fig. 3
14