Kenmore 7754 Use and Care Guide - Page 7

Before Using Your Range Assembly of Burner Heads & Burner Caps Your range is shipped with the Burner Heads and Burner Caps in the correct locations. Packing material may be located between the Burner Heads and the cooktop. The following instructions apply to all burners except the right front double burner• For assembly instructions for the double burner see the General Care & Cleaning section• a. Be sure to follow the installation instructions before installing and using your new range. b. Remove all packing tape from cooktop area. Remove all Burner Caps and Burner Heads. c. Discard all packing material located under Burner Heads. d. To replace Burner Heads & Caps, match the letters located under center of Burner Caps with the letters located inside Burner Heads (Fig. 1). e. Match the letters stamped on Burner Skirts with Burner Heads and Burner Caps (See Fig. 1). Replace the Burner Heads and Caps on cooktop (See Fig. 2). Carefully align the Electrodes into slot of each Burner Head (Fig. 3). Note: The Burner Heads should sit flat on Cooktop Burner Skirts. f. Unpack Burner Grates and position on the cooktop. • i i i ii ode Fig. -,uci'_ 3 Electrodes must align into slot for each Burner Head, except right front burner. Fig. 1