Kenmore 7754 Use and Care Guide - Page 38

Kenmore 7754 - Elite 30 in. Gas Range Manual

Page 38 highlights

General Care & Cleaning • • • Removing & Replacing Lift-OffOven Door DoorCare Instructions Care & Cleaning of Stainless Steel (some models) Removing & Replacing the Lift=Off Oven Door The door is heavy. For safe, temporary storage, lay the door flat with the inside of the door facing down. Door Hinge locations with oven door fully open To Remove Oven Door: 1. 2. Open oven door completely (horizontal with floor- See Fig. 1). Pull the door hinge locks on both left and right door hinges down from the oven frame completely towards the oven door (See Fig. 2). A tool such as a small flat-blade screwdriver may be required. Firmly grasp both sides of oven door along the door sides (Do not use the oven door handle - See Fig. 3). Close the door to the broil stop position (the oven door will stop into this position just before fully closing). With the oven door in the broil stop position, lift the oven door hinge arms over the roller pins located on each side of the oven frame (See Fig. 4). 3. Fig. 1 4. 5. Fig. 2 To Replace Oven Door: 1. Firmly grasp both sides of oven door along the door sides (Do not use the oven door handle - See Fig. 3). 2. Holding the oven door at the same angle as the removal position, seat the hook of the hinge arm over the roller pins located on each side of the oven door frame (See Fig. 4). The hook of the hinge arms must be fully seated onto the roller pins. 3. Fully open the oven door (horizontal with floor- See Fig. 1). 4. Push the door hinge locks up towards and into the oven frame on both left and right oven door hinges (See Fig. 2) to the locked position. 5. Close the oven door. Oven Door- Door Care instructions Most oven doors contain glass that can break. Read the following recommendations: 1. 2. 3. Do not close the oven door until all the oven racks are fully in place. Do not hit the glass with pots, pans, or any other object. Scratching, hitting, jarring or stressing the glass may weaken its structure causing an increased risk of breakage at a later time. Fi 1.3 Care & Cleaning of Stainless Steel (some models) Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining the appearance of stainless parts. Refer to the Care & Cleaning Table for detailed cleaning instructions. Fig. 4 38

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44

General
Care &
Cleaning
Removing & Replacing Lift-OffOven
Door
DoorCare
Instructions
Care & Cleaning
of Stainless
Steel (some models)
Fig. 2
Oven
Door-
Fi
Door
Hinge
locations
with
oven
door
fully
open
Fig. 1
1.3
Fig. 4
Removing
& Replacing
the
Lift=Off
Oven
Door
The door is heavy.
For safe, temporary
storage,
lay the door flat
with the inside of the door facing
down.
To Remove
Oven
Door:
1.
Open oven door completely
(horizontal
with floor-
See Fig. 1).
2.
Pull the door hinge locks on both left and right door hinges down from the
oven frame
completely
towards
the oven door (See Fig. 2). A tool such as a
small flat-blade
screwdriver
may be required.
3.
Firmly grasp both sides of oven door along the door sides (Do not use the
oven door handle - See Fig. 3).
4.
Close the door to the broil stop position
(the oven door will stop into this
position just before fully closing).
5.
With the oven door in the broil stop position,
lift the oven door hinge arms over
the roller pins located on each side of the oven frame
(See Fig. 4).
To Replace
Oven
Door:
1.
Firmly grasp both sides of oven door along the door sides (Do not use the
oven door handle - See Fig. 3).
2.
Holding the oven door at the same
angle as the removal
position, seat the
hook of the hinge arm over the roller pins located
on each side of the oven
door frame
(See Fig. 4). The hook of the hinge arms must be fully seated
onto the roller pins.
3.
Fully open the oven door (horizontal
with floor-
See Fig. 1).
4.
Push the door hinge locks up towards
and into the oven frame
on both left
and right oven door hinges (See Fig. 2) to the locked
position.
5.
Close the oven door.
Door
Care
instructions
Most
oven
doors
contain
glass
that
can break.
Read the following
recommendations:
1.
Do not close the oven door until all the oven racks are fully in place.
2.
Do not hit the glass with
pots, pans, or any other object.
3.
Scratching,
hitting, jarring
or stressing
the glass
may weaken
its structure
causing
an increased
risk of breakage
at a later time.
Care
& Cleaning
of Stainless
Steel
(some
models)
Some models
are equipped
with stainless
steel exterior
parts. Special care and
cleaning
are required
for maintaining
the appearance
of stainless
parts. Refer to
the Care & Cleaning
Table
for detailed
cleaning
instructions.
38