Kenwood KDC-MP635 Instruction Manual - Page 15

Display Type F G-Analyzer display Selection Changing the G-Analyzer display. ⁄ • Before alternating G-Analyzer display, you are required to setup (page 17), (page 18), (page 18) and (page 18). 1 Enter G-Analyzer display selection mode Using the Control knob, select "DISP" > "GMENU". For the operation method, refer to (page 10). 2 Select the G-Analyzer display Turn the Control knob. Select from the following displays. G-Force Sensor display G- Graphic display 1 - 2 • G-Counter display Adds the point of the acceleration level. The point is determined after a lapse of 1 hr drive or at power off (ACC Off ), and then it will be displayed by the graph. Furthermore, the G-Counter displays the average of the past data by the line. (The scale of graph is determined along with the largest point among the past 10 data.) • The value of G-Meter display and G-Counter display can be reset by (page 17). 3 Exit G-Analyzer display selection mode Press the Control knob. G-Meter display (Graphic) G-Meter display (Text) G-Counter display ⁄ • G-Graphic display Displays the condition of G in horizontal direction (e.g; when turning the curve) by the graphic. • G-Meter display (Graphic) Displays the maximum value of acceleration G, right direction G, and left direction G by the numerical value. • G-Meter display (Text) The maximum value of acceleration G, right direction G, and left direction G is displayed by the numerical value. The value of G is only the reference, so is different from the actual value. English | 15