Kodak Z1275 User Manual - Page 58
Camera/computer communications, Try one or more of the following, The Add New - usb drivers
UPC - 417780467082
View all Kodak Z1275 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Troubleshooting If Try one or more of the following Ready light blinks ■ Wait. Resume picture taking when the light stops blinking and turns amber. green. Ready light blinks ■ Install new batteries (see page 1) or charge rechargeable batteries. red and camera turns off. Ready light glows ■ Transfer pictures to the computer (see page 45), delete pictures from steady red. the camera (see page 15), switch image storage locations (see page 31), or insert a card with available memory (see page 3). ■ Wait. Resume picture taking when the light turns green. ■ Change the image storage location to internal memory (see page 31), or use a different card. Ready light is off or ■ Camera is operating normally. glows steady green. Camera/computer communications If Try one or more of the following The computer does ■ Turn on the camera (see page 2). not communicate ■ Install new batteries (see page 1) or charge rechargeable batteries. with the camera. ■ Connect cable to camera and computer port (see page 45). ■ Install the software (see page 44). ■ Disconnect the USB cable. Close all open applications. Re-install the software (see page 44). ■ Disconnect camera from the computer. Close all software applications, reconnect camera. Cannot transfer pictures. (The Add New Hardware Wizard cannot locate drivers.) ■ Disconnect USB cable. (If using camera dock or printer dock, disconnect cable and remove camera from dock). Close all open applications. Re-install the software (see page 44). ■ Disconnect the USB cable. Close all open applications. Re-install the software (see page 44). 52 www.kodak.com/go/support