Konica Minolta KIP C7800 User Manual - Page 45

Initial Cut (Straighten the leading edge of roll media)

Get Konica Minolta KIP C7800 PDF manuals and user guides View all Konica Minolta KIP C7800 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 45 highlights

2. 7 Initial Cut (Straighten the leading edge of roll media) A new roll media tends to have a rough or folded leading edge. Initial Cut will easily straighten the leading edge by cutting off such poor quality part of the media automatically. Pressing the Initial Cut Button cuts off the leading edge of the roll media in 120mm. NOTE Some roll media are taped at its leading edge. Even if you remove the tape, glue may remain on the leading edge. This would mess or damage the media path. Before using such a roll media, cut off some amount of the leading edge using a cutter knife and discard the portion with glue. 1. Draw out the concerned Roll Deck fully. DDrraaww oouutt ffuullllyy 2. Insert the leading edge between the feeding rollers. It will automatically go into the roll media's standby position. (Auto Media Loading) If the roll media has been set to standby position, go to the next step. Feeding rollers NOTE Auto Media Loading will pause unless "Door Open Error" (such as Bypass Feeder, Left Side Door, Rear Door or Paper Exit Door) or a mis-feed media is removed at all. 2-24 Chapter 2 Basic Operations

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
Chapter 2
Basic Operations
2-24
2. 7
Initial Cut
(Straighten the leading edge of roll media)
A new roll media tends to have a rough or folded leading edge. Initial Cut will easily straighten the
leading edge by cutting off such poor quality part of the media automatically.
Pressing the Initial Cut Button cuts off the leading edge of the roll media in 120mm.
1.
Draw out the concerned Roll Deck fully.
2.
Insert the leading edge between the feeding rollers. It will automatically go into the roll media’s
standby position. (Auto Media Loading)
If the roll media has been set to standby position, go to the next step.
NOTE
Some roll media are taped at its leading edge. Even if you remove the tape, glue may remain
on the leading edge. This would mess or damage the media path.
Before using such a roll media, cut off some amount of the leading edge using a cutter knife
and discard the portion with glue.
NOTE
Auto Media Loading will pause unless “Door Open Error” (such as Bypass Feeder, Left Side
Door, Rear Door or Paper Exit Door) or a mis-feed media is removed at all.
Draw out fully
Feeding rollers