Konica Minolta bizhub 181 bizhub 181 User Manual - Page 301
Troubleshooting, 8.1 When incorrect copies are produced, bizhub 181
View all Konica Minolta bizhub 181 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 301 highlights
8 Troubleshooting Troubleshooting Chapter 8 8 Troubleshooting 8.1 When incorrect copies are produced Symptom The copy is too light. Possible Cause Remedy Is the copy density set too light? Press the [Density] key and select the desired copy density. (See page 4-9.) Is the paper damp? Replace the paper with new paper. (See page 3-8.) The copy is too dark. Is the copy density set too dark? Press the [Density] key and select the desired copy density. (See page 4-9.) Was the document not pressed Position the document so that it close enough against the original is pressed closely against the glass? original glass. (See page 3-20.) The copy is blurry. Is the paper damp? Replace the paper with new paper. (See page 3-8.) Was the document not pressed Position the document so that it close enough against the original is pressed closely against the glass? original glass. (See page 3-20.) There are streaks in the Is the original glass dirty? copy. Wipe the glass with a soft, dry cloth. (See page 9-7.) Is the document pad dirty? Clean the document pad with a soft cloth dampened with a mild detergent. (See page 9-8.) There are dark specks or spots throughout the copy. Was the original document printed on highly translucent material, such as diazo photosensitive paper or overhead projector transparencies? Is a double-sided document being copied? Place a blank sheet of paper on top of the document. (See page 3-21.) If a thin double-sided document is being copied, the information on the back side may be reproduced in the copy. Press the [Density] key, and then select a lighter density setting. (See page 4-9.) The PC drum unit has reached Contact your service representa- the end of its service life. tive. 8-2 bizhub 181