Konica Minolta bizhub C360 bizhub C220/C280/C360 PKI Security Operations User - Page 36

Setup procedure for PKI card system, Installation of the loadable driver - c280 c220 driver

Get Konica Minolta bizhub C360 PDF manuals and user guides View all Konica Minolta bizhub C360 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 36 highlights

bizhub C360/C280/C220 for PKI Card System 11. Setup procedure for PKI card system Security Function Ver. 1.02 Jul. 2010 11. Setup procedure for PKI card system • After rewriting the firmware to the PKI card system, it is necessary to perform some setting to operate the PKI system. For details of the setting procedure, see "PKI card system setup instructions" and perform appropriate settings. 12. Installation of the loadable driver • The loadable driver is updated using the USB memory. A. Procedure 1. Prepare a USB memory on which the driver data of the loadable device to be used was written. 2. Turn OFF the main/sub power switch. 3. Insert the USB memory to the USB port of the machine. 4. Turn ON the main/sub power switch. 5. Call the Service Mode to the screen. 6. Touch [System 2]  [Driver Install]. Security Function A0EDS1E102DA 7. Touch [SET] to start installing the data. 8. Check that the control panel shows the message indicating that the data has been installed correctly. 9. Turn OFF the main power switch. 10. Remove the USB memory from the USB port. 32

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
11. Setup procedure for PKI card system
Security Function Ver. 1.02 Jul. 2010
32
bizhub C360/C280/C220
for PKI Card System
Security Function
11.
Setup procedure for PKI card system
•
After rewriting the firmware to the PKI card system, it is necessary to perform some set-
ting to operate the PKI system.
For details of the setting procedure, see “PKI card system setup instructions” and per-
form appropriate settings.
12.
Installation of the loadable driver
•
The loadable driver is updated using the USB memory.
A.
Procedure
1.
Prepare a USB memory on which the driver data of the loadable device to be used was
written.
2.
Turn OFF the main/sub power switch.
3.
Insert the USB memory to the USB port of the machine.
4.
Turn ON the main/sub power switch.
5.
Call the Service Mode to the screen.
6.
Touch [System 2]
[Driver Install].
7.
Touch [SET] to start installing the data.
8.
Check that the control panel shows the message indicating that the data has been
installed correctly.
9.
Turn OFF the main power switch.
10.
Remove the USB memory from the USB port.
A0EDS1E102DA