Konica Minolta bizhub C3850FS bizhub C3850FS/C3850/C3350 Quick Start Guide - Page 53

5 Using the fax function 5.3 5 Press the Start key. % Tap [Check Settings] before sending data, and check the specified destination and settings if necessary. % To redo operations for specifying destinations or option settings, press the Reset key. % If you press the Stop key while scanning the original, scanning stops. To cancel scanning the orig- inal, delete inactive jobs from the Job screen. Basic Usage Chapter 5 Sending starts. 5.3.3 Introduction of fax transmission function This section describes convenient fax transmission functions. For details on how to use each function, refer to Chapter 4 "Sending Options" in [User's Guide: Fax Functions]. Function Timer TX Check Dest. & Send F-Code TX Quick Memory TX Password TX Polling TX Overview Timer TX automatically starts sending at a specified time if the time is prespecified. Check Dest. & Send checks the fax number specified for the fax transmission against the destination fax number (CSI) and sends the fax only when they match. F-Code TX specifies the F code (SUB address and sending ID) to send a fax. Confidential communication and relay distribution request are available. • The confidential communication function is designed to communicate with specific people using a Confidential RX User Box that requires a registered number and a password. • Relay distribution request is a function that the relay station, which has received a fax, distributes the received fax to a pre-registered group. Fax transmission starts concurrently with scanning one page. The total number of pages transmitted can be entered in the sender record. Password TX sends a fax with a password. It is used to send faxes to a device on which fax peers are restricted by passwords (a device with Closed Network RX enabled). Polling TX stores a file beforehand on the internal hard disk and sends it out upon a request for reception (polling request) from the recipient. 5-14 [Quick Start Guide]