Konica Minolta bizhub PRESS 1250 bizhub PRESS 1052/1250/1250P Additional Infor - Page 29

2.2 Operating the Machine with the External Finisher 2 15 Measure the paper size, thickness, and so forth of the output sheet and then enter the values for the External Finisher. The items to be set vary with the External Finisher being used. For details, refer to the External Finisher's documentation. 16 On the Mode Check Screen of the main body's control panel, change the output settings (External Fin- isher (External FNS): ON, Output Tray: External Finisher tray) and start printing samples. Press [Proof Copy] to output a whole set or press [Proof Print(1st Sheet)] to output only the first sheet. 17 Check the finish of the output sheet. 18 If the expected result is not achieved, repeat steps 16 and 17 to make adjustments. For details, refer to the External Finisher's documentation. 19 Press [Close] to close the Mode Check Screen. 20 Press Start on the control panel to start the actual printing. 2.2.5 Sample Print (Printing) This section describes how to print samples using a Wait job. Proof print or Hold print (displayed as "Suspended" when operated from the control panel) can also be used to print samples as needed. 1 Send a Wait job from the printer driver. PCL driver: Select [Basic] - [Print Method] then select [Wait Mode]. PS Plug-in driver (Windows/Macintosh): Select [Workflow] - [Print Mode] then select [Wait Mode]. PPD driver (Windows): Select [Advanced] - [Print Mode] then select [Wait Mode]. PPD driver (Macintosh): Select [Security] - [Print Mode] then select [Wait Mode]. 2 On the Mode Check Screen of the main body's control panel, change the output settings (External Fin- isher (External FNS): ON, Output Tray: secondary (sub) tray of Large Capacity Stacker LS-505 or Large Capacity Stacker LS-506) and start printing samples. bizhub PRESS 1250/1250P/1052 2-23