Kyocera KM-5530 Print System Q Operators Guide (Setup) - Page 11

2. Set-up 2-4 Network (TCP/IP) settings To use the printer as a network printer, it is necessary to set an IP address for the printer. Notes • The IP address that should be registered here will differ depending upon your network environment. Check with your network administrator BEFORE performing this setting. • If you are using a DHCP server to automatically configure the IP address, this setting will not be necessary because DHCP server configuration is already enabled as the factory default setting. * To cancel the setting midway through it, press the Stop/Clear key. 1 Press the Printer key. The printer will switch to the printer mode. 5 Use the "L" and "M" cursor keys to select "TCP/IP" and then touch the "Change" key. 6 Select "ON" under the "TCP/IP" setting and "OFF" under the "DHCP" setting. 2 Touch the "Printer Menu" key. 7 Use the "L" and "M" cursor keys to select "IP Address" and then touch the "Change" key. 3 Touch the "Interface" key. 8 Use the numeric keys to input the address. Input the first block of 3 digits of the address in the highlighted area. • Press the sharp (#) key to set the address after inputting each block of 3 digits. 4 Touch the "Network" key and then the "Detail" key. 6