Kyocera KM-5530 Print System Q Operators Guide (Setup) - Page 12
Subnet Mask
View all Kyocera KM-5530 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
9 Enter the next 3 digits and press the sharp (#) key. • To change an entered address, press the sharp (#) key to select a 3-digit block and use the numeric keys to enter the correct address. 2. Set-up 13 Use the "L" and "M" cursor keys to select "Gateway" and touch the "Change" key. 10 Repeat the same procedure for the remaining blocks of the address. Once the input of the IP address is completed, touch the "Close" key. The display will return to the "TCP/IP" screen. • To cancel the entered address, touch the "Back" key. The address that was shown before you entered a new address will reappear. 14 Enter the Gateway address in the same way you entered the IP address in steps 8 to 10. 15 When you are finished making all of the network settings, touch the "Close" key. 11 Use the "L" and "M" cursor keys to select "Subnet Mask" and touch the "Change" key. 16 Touch the "Close" key. 12 Enter the Subnet Mask address in the same way you entered the IP address in steps 8 to 10. 17 Touch the "Close" key. The printer will switch back to the printer mode. 7