LG 22SM3B User Guide - Page 47

ENGLISH 49. IR Operation (Command: t p) Configures the IR operation settings of the product. Transmission [t][p][ ][Set ID][ ][Data][Cr] Data 00: locks off all of the keys 01: locks on all of the keys except the Power key 02: locks on all of the keys Acknowledgement [x][ ][Set ID][ ][OK/NG][Data][x] * When the monitor is turned off, the power key works even in the locks on all of the keys (02) mode. 47 52. Check Screen (Command: t z) Sets Check Screen. Transmission [t][z][ ][Set ID][ ][Data][Cr] Data 00: Off 01: On Acknowledgement [z][ ][Set ID][ ][OK/NG][Data][x] ** It may not be supported depending on the model. 50. Local Key Operation (Command: t o) Configures the local key operation settings of the product. Transmission [t][o][ ][Set ID][ ][Data][Cr] Data 00: locks off all of the keys 01: locks on all of the keys except the Power key 02: locks on all of the keys Acknowledgement [o][ ][Set ID][ ][OK/NG][Data][x] * When the monitor is turned off, the power key works even in the locks on all of the keys (02) mode. ** It may not be supported depending on the model. 53. Speaker (Command: d v) Sets the speaker function. Transmission [d][v][ ][Set ID][ ][Data][Cr] Data 00: Off 01: On Acknowledgement [v][ ][Set ID][ ][OK/NG][Data][x] ** It may not be supported depending on the model. 51. Status (Command: s v) Checks the current signal status of the product. Transmission [s][v][ ][Set ID][ ][Data][ ][FF][Cr] Data 02: checks whether there is a signal or not 03: check the PM mode. 10: RGB sensing OK/NG (Check Screen) Acknowledgement [v][ ][Set ID][ ][OK/NG][Data][Data1][x] Data: Data1 02 (when a signal is found) 00: no signal 01: there is a signal Data: Data1 03 (when checking the PM mode) 00: The PM mode is set to Screen On 01: The PM mode is set to Screen Off 02: The PM mode is set to Screen Off Always Data: Data1 10 (Check Screen) 00: Check Screen result NG 07: Check Screen result OK * Sets to NG when Check Screen is set to Off or not supported. ** It may not be supported depending on the model. 54. Daylight Saving Time (Command: s d) To set theDaylight Saving Time function. Transmission [s][d][ ][Set ID][ ][Data1][ ][Data2][ ][Data3][ ][Data4] [ ][Data5][Cr] Data 00: Off (Data2~5: FFH) 01: Start Time 02: End Time Data2 01~0C: January to December Data3 01~06: 1 ~ 6th week * The maximum number of [Data3] differs depending on Date. Data4 00~06 ( Sun. ~ Sat. ) Data5 00~17: 00 ~ 23 hours * To read the Start Time/End Time, enter FFH for [Data2]~[Data5]. (ex1: sd 01 01 ff ff ff ff - To check the Start Time ex2: sd 01 02 ff ff ff ff - To check the End Time) * This function is supported only when 1 (Year/Month/ Day) and 2 (Hour/Minute/Second) are set. Acknowledgement [d][ ][Set ID][ ][OK/NG][Data1][Data2][Data3][Data4] [Data5][x] ** It may not be supported depending on the model.