LG 37LD325H Owners Manual - Page 187

Clonable Menu Features, IMPORTANT CLONING INFORMATION, a TV RF source

Page 187 highlights

Cloning Overview / Clonable Menu Features IMPORTANT CLONING INFORMATION There are three options for cloning a Master TV Setup: • Using a USB memory device • Using a TLL-1100A clone programmer • Using a LT2002 clone programmer Each option is described in further detail on the pages that follow. As you perform cloning procedures, be sure to complete each task as indicated. If a procedure or step is omitted or not performed completely, cloning may not work. At each step, pay attention to ensure the TV screen shows the proper message when cloning. If the message indicated does not appear, there is a problem with that step, and cloning may not be successful. Warning: Copying a blank or incorrect memory into a TV will cause the TV to operate erratically or become inoperable. Warning: Do not connect a clone programmer to a PPV card installed in the Master or Target TVs, as this will damage the clone programmer and the PPV card. Before you begin cloning: • Complete the Commercial Mode Setup for Master TV procedure on pages 12 to 13. • Ensure Installer Menu items on Target TVs are set/restored to factory default settings (i.e., set Installer Menu item 117 FACT DEFAULT to 001 on Target TVs) before Teaching is initiated. • All equipment should be connected to power and turned ON. • Learning and Teaching is only possible between identical model TVs. • The Master and Target TVs must be in Pass-through Mode. • If using a USB memory device, ensure the USB device has been formatted with FAT format. • For both Master and Target TVs-If using a clone programmer, ensure the TV signal source is either an Aux or TV (RF) source. If a TV (RF) source, the TV must be tuned to an analog (not a digital) channel. • LT2002 only-Make sure the batteries in the clone programmer are fresh. If batteries are removed, the clone programmer clock time (if set) will be lost (see page 28 for information on the clone programmer clock). • Do not unplug the TV power cord or remove/disconnect the USB memory device/clone programmer while Learning or Teaching, as doing so may cause the TV to malfunction or harm the USB device/ clone programmer, respectively. Clonable Menu Features Installer Menu Installer Menu item settings Channel Auto Tuning (Channel Lineup) Manual Tuning Channel Edit Channel Label Picture Aspect Ratio Picture Mode Advanced Control Audio Auto Volume Clear Voice Sound Mode Balance TV Speaker Option Menu Language Audio Language Caption Caption Mode Digital Caption Options Lock Movie Rating TV Rating - Children TV Rating - General Input Block Time Auto Clock Manual Clock Off Time On Time Auto Off (Sleep Timer) Note: Some menu options vary between analog and digital channels and Aux sources. 206-4177 23

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
  • 197
  • 198
  • 199
  • 200
  • 201
  • 202
  • 203
  • 204
  • 205
  • 206
  • 207
  • 208
  • 209
  • 210
  • 211
  • 212

23
206-4177
There are three options for cloning a Master
TV Setup:
• Using a USB memory device
• Using a TLL-1100A clone programmer
• Using a LT2002 clone programmer
Each option is described in further detail on
the pages that follow. As you perform cloning
procedures, be sure to complete each task as
indicated. If a procedure or step is omitted or
not performed completely, cloning may not
work. At each step, pay attention to ensure the
TV screen shows the proper message when
cloning. If the message indicated does not
appear, there is a problem with that step, and
cloning may not be successful.
Warning: Copying a blank or
incorrect memory into a TV will
cause the TV to operate erratically
or become inoperable.
Warning: Do not connect a clone
programmer to a PPV card installed
in the Master or Target TVs, as this
will damage the clone programmer
and the PPV card.
Installer Menu
Installer Menu item settings
Channel
Auto Tuning (Channel Lineup)
Manual Tuning
Channel Edit
Channel Label
Picture
Aspect Ratio
Picture Mode
Advanced Control
Audio
Auto Volume
Clear Voice
Sound Mode
Balance
TV Speaker
Option
Menu Language
Audio Language
Caption
Caption Mode
Digital Caption Options
Lock
Movie Rating
TV Rating – Children
TV Rating – General
Input Block
Time
Auto Clock
Manual Clock
Off Time
On Time
Auto Off (Sleep Timer)
Cloning Overview / Clonable Menu Features
Note:
Some menu options vary between analog and digital channels and Aux sources.
Clonable Menu Features
IMPORTANT CLONING INFORMATION
Before you begin cloning:
• Complete the Commercial Mode Setup for Master TV procedure on
pages 12 to 13.
• Ensure Installer Menu items on Target TVs are set/restored to factory
default settings (i.e., set Installer Menu item 117 FACT DEFAULT to
001 on Target TVs) before Teaching is initiated.
All equipment should be connected to power and turned ON.
• Learning and Teaching is only possible between identical model TVs.
• The Master and Target TVs must be in Pass-through Mode.
• If using a USB memory device, ensure the USB device has been
formatted with FAT format.
• For both Master and Target TVs—If using a clone programmer,
ensure the TV signal source is either an Aux or TV (RF) source. If
a TV (RF) source, the TV must be tuned to an analog (not a digital)
channel.
• LT2002 only—Make sure the batteries in the clone programmer are
fresh. If batteries are removed, the clone programmer clock time (if
set) will be lost (see page 28 for information on the clone program-
mer clock).
• Do not unplug the TV power cord or remove/disconnect the USB
memory device/clone programmer while Learning or Teaching, as
doing so may cause the TV to malfunction or harm the USB device/
clone programmer, respectively.