LG L26W56S Operation Guide - Page 40

Cloning Connections/Learning Setup Connections for the LT2002 Clone Programmer to Learn the L26W56X Master TV Setup. Antenna or CATV Ferrite Core (TDK, ZCAT 2035-0930) Warning: Do not use LT2002 if a LodgeNet PPV card is installed in TV or clone programmer device will be damaged. THE CLONE HAS CONTROL OF THE TV THE CLONE IS VERSION XX THE TV IS VERSION XX THE SW IS REVISION XX CLONE CLOCK = XX:XX TV CLOCK = XX:XX -PRESS ANY KEY TO CONTINUE. -DISCONNECT CLONE WHEN DONE. Master L26W56X ¤ QuickSet II Programmer LT2002 Clone Programmer Notes: It is assumed that the L26W56X is connected to a signal source, the source selected is Antenna (RF) In, the signal is from an Analog channel, not a digital channel, all equipment is connected to power and turned on and the LT2002 Clone Programmer main menu (THE CLONE HAS CONTROL OF THE TV) menu is displayed on the TV screen, see above and next page. Before you begin cloning... • The Master L26W56X should be connected to a good, stable signal from an over-the-air antenna or cable service Analog channel and connected to power. (See above.) • Teaching and Learning is only possible between identical model devices. (However, the LT2002 Clone programmer can store up to 3 different 'master' setups.) WARNING: Copying a blank or incorrect memory into a TV, STB or other device will cause the TV, STB or other device to operate erratically or become inoperable. • Use an Installer's remote to operate Learning and Teaching menus. • Make sure that the batteries in the Clone programmer are fresh. • If batteries are removed, the Clone Clock time will be lost. • Decide if you want to set the time from the Clone programmer TV which has the clock set to the current time. • Setting the time and transferring it to the Clone or other device is a separate procedure. • Follow the connection diagram above to connect the Clone to a Master L26W56X TV display panel. After learning is complete, to another identical L26W56X TV display panel to "teach" it the master setup. • After the L26W56Xs setup has been copied to another identical L26W56X, that identical unit with the copied setup, needs to be disconnected from power for about 15 seconds to activate the newly-copied setup. • See the Clone Troubleshooting section to resolve problems. Turn to the next page to continue Cloning Setup. Turn to the next page to continue Cloning Setup. PAGE 40