LG L26W56S Operation Guide - Page 56

Reference: Cloning Procedure Troubleshooting Warning: Do not use LT2002 while a LodgeNet PPV card is installed in TV or clone programmer will be damaged. Reset Clone After Static Shock After replacing exhausted batteries, or if the programmer behaves strangely after a static shock, activate the internal reset switch and restore normal operation. After a reset, check the real-time clock setting. It may be necessary to reset the Clone Programmer clock from a TV containing the correct time. Note The LT2002 programmer is designed to be used with TVs containing the 221-01006 and later processors. Use with earlier TV sets may give unpredictable results. Processors used before the 221-01006-04 have a limited screen display capability. They cannot display entire screens as shown in the quick setup instructions accompanying the LT2002 clone programmer. Use the printed menu illustrations on the quick setup sheet supplied with the Clone as an aid to making your programming choices. (Although the menus are not all displayed, the clone functions all operate normally.) Clone Programmer Troubleshooting Clone Programmer Cloning Notes: While clone is copying or transferring a master setup, do not touch or otherwise disturb clone or connections between clone and TV. Cloning a master TV setup should take at least 45 seconds. Transferring the master TV setup to the target TV should take at least 45 seconds. Monitor LED on clone to assure that the blinking heartbeat pattern is present throughout clone operations. After cloning, be sure to disconnect power from the target TV for about 15 seconds. Problem Remote does not operate clone. LED does not blink. Clone menu hard to read. No time set. Possible Cause(s) • Wrong Installer remote. • M.P.I. cord not connected. • L26W56X not turned on. • Weak batteries. • Weak signal. • Time not available. Possible Solution(s) - Only use an appropriate Installer remote to operate clone program- mer with L26W56X. - Connect M.P.I. cord. - L26W56X must be powered On for clone to work. - Install 4 fresh AA high-quality alkaline batteries. - Connect L26W56X to a reliable Analog channel signal source. - Set time on a TV, copy time to Clone Programmer. Clone not working. • Clone programmer problem. Clone Scans Channels • Clone should only scan more than once. channels once. - Try a different LT2002 Clone programmer. - Reset Clone Programmer. - Retry cloning again. Master and Other L26W56X Cloning did not work. • Procedure interrupted. • Different TV models. • Step(s) omitted or not performed. Clone time disappeared. • Batteries were removed. New Setup not present. • L26W56X not reset. - Wait until procedure complete message is displayed. - Cloning is only possible with identical model TVs. - Reread 40 - 41 - 42 pages to be sure all tasks were performed. - Batteries must remain installed to retain time settings. - Disconnect newly cloned unit from power for 5 seconds. • After cloning operations are complete, just unplug the LT2002 from the L26W56X. • If the L26W56X does not display a picture on the TV (blank screen) after a few seconds, just change channels. PAGE 56