LG LUWD1CW Owners Manual - Page 13
Choosing the Proper, Location
View all LG LUWD1CW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Choosing the Proper Location Install the washer on a solid floor that is strong and rigid enough to support the weight of the washer, even when fully loaded, without flexing or bouncing. If the floor has too much flex, you may need to reinforce it to make it more rigid. If the floor is not solid, it may cause severe vibration and noise. NOTE ••Before installing the washer, make sure the floor is clean, dry and free of dust, dirt, water and oil so the washer feet cannot slide easily. Leveling feet that can move or slide on the floor can contribute to excess vibration and noise due to poor contact with the floor. ••Allow for sufficient space between the walls and the washer for installation. Power Outlet ••The power outlet must be within 60 inches (1.5 m) of either side of the washer. ••The appliance and outlet must be positioned so that the plug is easily accessible. ••Do not overload the outlet with more than one appliance. ••The outlet must be grounded in accordance with current electrical wiring codes and regulations. ••Use a time-delay fuse or circuit breaker. NOTE ••It is the personal responsibility and obligation of the product owner to have a proper outlet installed by a qualified electrician. Flooring ••To minimize noise and vibration, the washer must be installed on a solidly constructed floor. ••Allowable slope under the entire washer is a maximum 1/2 inches difference from side to side or from front to back. ••Installing on carpeting and soft tile surfaces is not recommended. ••Never install the washer on a platform or weakly supported structure. INSTALLATION 13 NOTE ••The washer must be installed on firm flooring to minimize vibration during the spin cycle. Concrete flooring is best, but a wood floor is sufficient, provided it is built to FHA standards. Floor Installation 53 1 / 8 " 48 1 / 2 " 0.2" 49 1 / 4 " 1" 42 1 / 8 " * 49 1/ 4" 23 5 / 8 " 4" 1" 1" * 49 1/4" : Minimum space for installation To ensure sufficient clearance for water lines, the drain line and airflow, allow minimum clearances of at least 1 inch (2.5 cm) at the sides and 4 inches (10 cm) behind the unit. Be sure to allow for wall, door, or floor moldings that may increase the required clearances. NOTE ••Do not use a drip pan as it can block the drawer. Using a drip pan may result in increased vibration and noise during operation. ENGLISH