Lacie 2big Network 2 User Manual - Page 14
STEP 2: Connect the Ethernet Cable, Gigabit Ethernet Cables And Connectors - blinking blue
View all Lacie 2big Network 2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
LaCie 2big Network 2 • DESIGN BY NEIL POULTON User Manual 2.2. STEP 2: Connect the Ethernet Cable 1. Connect the Ethernet cable to the Ethernet port on the back of the LaCie 2big Network 2 (Fig. 04). 2. Connect the other end of the Ethernet cable into an available Ethernet "out" port on your router or hub (refer to your router or hub's documentation if necessary). 3. Turn on the drive by pressing the power button on the back of the drive (Fig. 05). The front LED will turn on and then begin blinking. The drive is ready to be accessed once the blue LED has stopped blinking. The product may take up to 3 minutes to boot. Now move on to step 3, section 2.3. STEP 3: Connect using LaCie Network Assistant. TECHNICAL NOTE: Depending on your computer's Ethernet settings, you may be able to connect the 2big Network 2 directly to your computer using the Ethernet cable. Fig. 04 Gigabit Ethernet Cables And Connectors See Fig. 06 for an illustration of the Ethernet cable used to connect your LaCie 2big Network 2 to your network device. The ends of the Ethernet cable are the same and either end can be connected to the LaCie 2big Network 2 or your router. Fig. 05 Connecting to a Network page 14 Fig. 06 - Gigabit Ethernet cable ends