Lenovo ThinkPad T410 Hardware Maintenance Manual - Page 51

Enter BIOS Setup Utility by entering supervisor, Load Setup Defaults in BIOS Setup Utility. - keyboard not working

Get Lenovo ThinkPad T410 PDF manuals and user guides View all Lenovo ThinkPad T410 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 51 highlights

Table 2. Numeric error codes (continued) Symptom or error FRU or action, in sequence 0192 System Security- Embedded Security hardware tamper detected. System board. 0193 RF antenna has been removed Enter the supervisor password. 0194 The computer has been carried through a security gate Enter the supervisor password. 0195 Security hardware tamper detected 1. Enter BIOS Setup Utility by entering supervisor password, and select "Password ➙ Security Chip ➙ Clear Security Chip" to clear this error. 2. Security chip. 3. System board. 0196 Security hardware removed 1. Enter BIOS Setup Utility by entering supervisor password, and select "Password ➙ Security Chip ➙ Clear Security Chip " to clear this error. 2. Security chip. 3. System board. 0197 Invalid remote change requested. The remote configuration for the security chip has failed. Confirm the operation and try again. 0199 System Security- Security password retry count exceeded. 1. Run BIOS Setup Utility, and then save the current setting by pressing F10. 2. System board. 01C8 Two or more modem devices are found. Remove all but one of them. Press to continue. 1. Remove either a Mini-PCI Card or a modem daughter card. Otherwise, press Esc to ignore the warning message. 2. System board. 01C9 Two or more Ethernet devices are found. Remove all but one of them. Press to continue. 1. Remove either a Mini PCI Ethernet card or an Ethernet daughter card. Otherwise, press Esc to ignore the warning message. 2. System board. 01C9 More than one Ethernet devices are found. Remove one of them. Press to continue. 1. Remove the Ethernet device that you installed; or press Esc to ignore the warning message. 2. System board. 01CA More than one Wireless LAN devices are found. Remove one of them. 1. Remove the wireless LAN device that you installed. 2. System board. 0200 Hard disk error-The hard disk is not working. 1. Reseat the hard disk drive. 2. Load Setup Defaults in BIOS Setup Utility. 3. Hard disk drive. 4. System board. 021x Keyboard error. Run interactive tests of the keyboard and the auxiliary input device. 0220 Load Setup Defaults in BIOS Setup Utility. Monitor type error-Monitor type does not match the one specified in CMOS. 0230 Shadow RAM error-Shadow RAM fails at offset nnnn. System board. 0231 System RAM error-System RAM fails at offset nnnn. 1. DIMM. 2. System board. Chapter 4. Related service information 45

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
Table 2. Numeric error codes (continued)
Symptom or error
FRU or action, in sequence
0192
System Security— Embedded Security hardware tamper
detected.
System board.
0193
RF antenna has been removed
Enter the supervisor password.
0194
The computer has been carried through a security gate
Enter the supervisor password.
0195
Security hardware tamper detected
1.
Enter BIOS Setup Utility by entering supervisor
password, and select “Password
➙
Security Chip
➙
Clear Security Chip” to clear this error.
2. Security chip.
3. System board.
0196
Security hardware removed
1.
Enter BIOS Setup Utility by entering supervisor
password, and select “Password
➙
Security Chip
➙
Clear Security Chip ” to clear this error.
2. Security chip.
3. System board.
0197
Invalid remote change requested.
The remote configuration for the security chip has
failed. Confirm the operation and try again.
0199
System Security— Security password retry count
exceeded.
1.
Run BIOS Setup Utility, and then save the current
setting by pressing F10.
2. System board.
01C8
Two or more modem devices are found. Remove all but
one of them. Press <Esc> to continue.
1.
Remove either a Mini-PCI Card or a modem
daughter card. Otherwise, press Esc to ignore
the warning message.
2. System board.
01C9
Two or more Ethernet devices are found. Remove all but
one of them. Press <Esc> to continue.
1.
Remove either a Mini PCI Ethernet card or an
Ethernet daughter card. Otherwise, press Esc to
ignore the warning message.
2. System board.
01C9
More than one Ethernet devices are found. Remove one
of them. Press <Esc> to continue.
1.
Remove the Ethernet device that you installed; or
press Esc to ignore the warning message.
2. System board.
01CA
More than one Wireless LAN devices are found. Remove
one of them.
1.
Remove the wireless LAN device that you
installed
.
2. System board.
0200
Hard disk error—The hard disk is not working.
1.
Reseat the hard disk drive.
2. Load Setup Defaults in BIOS Setup Utility.
3. Hard disk drive.
4. System board.
021x
Keyboard error.
Run interactive tests of the keyboard and the auxiliary
input device.
0220
Monitor type error—Monitor type does not match the one
specified in CMOS.
Load Setup Defaults in BIOS Setup Utility.
0230
Shadow RAM error—Shadow RAM fails at offset nnnn.
System board.
0231
System RAM error—System RAM fails at offset nnnn.
1.
DIMM.
2. System board.
Chapter 4
.
Related service information
45