Lenovo ThinkPad W530 Hardware Maintenance Manual - Page 46

Numeric error codes, Enter ThinkPad Setup. - The checksum of the Security - ultrabay

Get Lenovo ThinkPad W530 PDF manuals and user guides View all Lenovo ThinkPad W530 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 46 highlights

Numeric error codes Table 1. Numeric error codes Symptom or error FRU or action, in sequence 0177: Bad SVP data, stop POST task. - The checksum System board of the supervisor password in the EEPROM is not correct. 0183: Bad CRC of Security Settings in EFI Variable. Enter ThinkPad Setup. - The checksum of the Security settings in the EFI Variable is not correct. Enter ThinkPad Setup to correct Security settings in the EFI Variable. 0187: EAIA data access error. System board 0188: Invalid RFID Serialization Information Area. - The System board EEPROM checksum is not correct (Block #0,1). 0189: Invalid RFID configuration Information Area. - The System board EEPROM checksum is not correct (Block #4,5). 0190: Critical low-battery error • Charge the battery pack. • Battery pack 0191: System Security - Invalid Remote Change requested. • Run ThinkPad Setup, and then save the current setting by pressing F10. • System board 0199: System Security - Security password retry count exceeded. • Run ThinkPad Setup, and then save the current setting by pressing F10. • System board 0251: System CMOS checksum bad - Default configuration used 1. Charge the backup battery for more than 8 hours by connecting the ac adapter. 2. Replace the backup battery and run ThinkPad Setup to reset the time and date. 0253: EFI Variable Block Data was destroyed. 0271: Real-Time Clock Error. Check Date and Time settings. Run ThinkPad Setup to reset the time and date. 1802: Unauthorized network card is plugged in - Power off and remove the mini PCI network card. • Remove Mini PCI network card. • System board 1820: More than one external fingerprint reader is attached. Power off and remove all but the reader that you set up within your main operating system. Remove all but the reader that you set up for the authentication. 2000: ThinkVantage® Active Protection sensor diagnostics System board failed. 2100: Detection error on HDD0 (Main HDD) 1. Reseat the hard disk drive. 2. Main hard disk drive 3. System board 2101: Detection error on HDD1 (Ultrabay HDD) 1. Reseat the hard disk drive. 2. Ultrabay® hard disk drive 3. System board 2102: Detection error on HDD2 (Mini SATA) 1. Reseat the Mini SATA device. 2. Mini SATA device 3. System board 2110: Read error on HDD0 (Main HDD) 1. Reseat the hard disk drive. 2. Main hard disk drive 3. System board 40 Hardware Maintenance Manual

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
Numeric error codes
Table 1. Numeric error codes
Symptom or error
FRU or action, in sequence
0177: Bad SVP data, stop POST task. — The checksum
of the supervisor password in the EEPROM is not correct.
System board
0183: Bad CRC of Security Settings in EFI Variable.
Enter ThinkPad Setup. — The checksum of the Security
settings in the EFI Variable is not correct.
Enter ThinkPad Setup to correct Security settings in
the EFI Variable.
0187: EAIA data access error.
System board
0188: Invalid RFID Serialization Information Area. — The
EEPROM checksum is not correct (Block #0,1).
System board
0189: Invalid RFID configuration Information Area. — The
EEPROM checksum is not correct (Block #4,5).
System board
0190: Critical low-battery error
•
Charge the battery pack.
•
Battery pack
0191: System Security - Invalid Remote Change
requested.
•
Run ThinkPad Setup, and then save the current
setting by pressing F10.
•
System board
0199: System Security - Security password retry count
exceeded.
•
Run ThinkPad Setup, and then save the current
setting by pressing F10.
•
System board
0251: System CMOS checksum bad - Default
configuration used
1.
Charge the backup battery for more than 8 hours
by connecting the ac adapter.
2. Replace the backup battery and run ThinkPad Setup
to reset the time and date.
0253: EFI Variable Block Data was destroyed.
0271: Real-Time Clock Error. Check Date and Time
settings.
Run ThinkPad Setup to reset the time and date.
1802: Unauthorized network card is plugged in - Power
off and remove the mini PCI network card.
•
Remove Mini PCI network card.
•
System board
1820: More than one external fingerprint reader is
attached. Power off and remove all but the reader that
you set up within your main operating system.
Remove all but the reader that you set up for the
authentication.
2000: ThinkVantage
®
Active Protection sensor diagnostics
failed.
System board
2100: Detection error on HDD0 (Main HDD)
1.
Reseat the hard disk drive.
2. Main hard disk drive
3. System board
2101: Detection error on HDD1 (Ultrabay HDD)
1.
Reseat the hard disk drive.
2. Ultrabay
®
hard disk drive
3. System board
2102: Detection error on HDD2 (Mini SATA)
1.
Reseat the Mini SATA device.
2. Mini SATA device
3. System board
2110: Read error on HDD0 (Main HDD)
1.
Reseat the hard disk drive.
2. Main hard disk drive
3. System board
40
Hardware Maintenance Manual