Lexmark Z2320 User's Guide - Page 15
Transparencies, Custom-size paper, The total thickness of paper does not exceed 10 mm 0.4 inches.
View all Lexmark Z2320 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Make sure: • You follow the loading instructions that came with the labels. • The print side of the labels faces you. • The adhesive on the labels does not extend to within 1 mm of the edge of the label. • You use full label sheets. Partial sheets (with areas exposed by missing labels) may cause labels to peel off during printing, resulting in a paper jam. • The labels are loaded against the right side of the paper support. • The paper guide rests against the left edge of the labels. Transparencies Load up to 10 transparencies. Make sure: • The rough side of the transparencies faces you. • You don't use transparencies with paper backing sheets. • The transparencies are loaded against the right side of the paper support. • The paper guide rests against the left edge of the transparencies. Note: Transparencies require more drying time. Remove each transparency as it exits, and allow it to dry to avoid ink smudging. Custom-size paper Load up to 100 sheets of custom-size paper (depending on the thickness). Make sure: • The total thickness of paper does not exceed 10 mm (0.4 inches). • The print side of the paper faces you. • The paper size fits within these dimensions: Width: - 76-216 mm - 3.0-8.5 inches Length: - 127-432 mm - 5.0-17.0 inches • The paper is loaded against the right side of the paper support. • The paper guide rests against the left edge of the paper. 15