Linksys SPA921 Cisco Small Business IP Phone SPA9X1 Administration Guide - Page 79
Dial Plan Timers, Interdigit Long Timer
UPC - 745883570799
View all Linksys SPA921 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
Configuring a Dial Plan Chapter 3 Managing Linksys IP Phones The following also allows 7-digit US-style dialing, and automatically inserts a 1 + 212 (local area code) in the transmitted number. ( 1 xxx xxxxxxx | xxxxxxx ) For an office environment, the following plan requires a user to dial 8 as a prefix for local calls and 9 as a prefix for long distance. In either case, an "outside line" tone is played after the initial 8 or 9, and neither prefix is transmitted when initiating the call. ( 1 xxx xxxxxxx | xxxxxxx ) The following allows only placing international calls (011 call), with an arbitrary number of digits past a required 5 digit minimum, and also allows calling an international call operator (00). In addition, it lengthens the default short interdigit timeout to 4 seconds. S:4, ( 00 | 011 xxxxx x. ) The following allows only US-style 1 + area-code + local-number, but disallows area codes and local numbers starting with 0 or 1. It also allows 411, 911, and operator calls (0). ( 0 | [49]11 | 1 [2-9]xx [2-9]xxxxxx ) The following allows US-style long distance, but blocks 9xx area codes: ( 1 [2-8]xx [2-9]xxxxxx ) The following allows arbitrary long distance dialing, but explicitly blocks the 947 area code. ( 1 947 xxxxxxx ! | 1 xxx xxxxxxx ) The following implements a hot line phone, which automatically calls 1 212 5551234. ( S0 ) The following provides a warm line to a local office operator (1000) after five seconds, unless a four-digit extension is dialed by the user. ( P5 | xxxx ) Dial Plan Timers The dial plan functionality is regulated by the following configurable parameters: • Interdigit_Long_Timer • Interdigit_Short_Timer • Dial_Plan ([1] and [2]) Interdigit Long Timer ParName Default Interdigit_Long_Timer 10 The specifies the default maximum time (in seconds) allowed between dialed digits, when no candidate digit sequence is as yet complete (see the discussion of the Dial_Plan parameter for an explanation of candidate digit sequences). 3-36 Linksys IP Phone Administrator Guide Firmware Version 5.1