Linksys SPA921 Cisco SPA9000 Voice System Web-UI Based Product Installation an - Page 86
Reboot OK. Go to Setup Setting Up Each Station,
UPC - 745883570799
View all Linksys SPA921 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
Configuring Phone Service and Voice Mail Configuring the SPA400 STEP 5 Restart the SPA400 by completing the following steps: a. Click Administration tab > Reboot. 5 b. Click Restart System. c. When the confirmation message appears, click OK. The SPA400 reboots. d. When the Reboot OK. Go to Setup Page? message appears, click OK. STEP 6 To verify your progress, click the Status tab, and verify the following settings: a. USB status: Mount b. Voice mail status: OK c. SPA9000 Registration status: Registered NOTE If the SPA registration status is not Registered, disconnect power to the SPA9000 and then reconnect power after a short wait. After the SPA9000 and the phones reboot, click Refresh on the SPA400 Status page. STEP 7 Continue to the next procedure, "Setting Up Each Station," on page 85. SPA9000 Voice System Installation and Configuration Guide for Web UI 84