Mackie M1400/M1400i Owner's Manual - Page 13

SIG SIG (short for "signal present") is the lowest step in the meters' ladder. It senses the signal prior to the GAIN control, so when SIG is lit, you know the M•1400/M•1400i is receiving signal. If it's the only meter LED lit (meaning the other meter LEDs are not lit), the M•1400/ M•1400i is receiving a very weak signal (below -20 dB). PROTECT If the PROTECT LEDs are on, the M•1400/ M•1400i's output section has shut down. That, of course, means you won't hear anything until you rectify the situation. Three things can cause the PROTECT circuit to engage: 1. Powering up the M•1400/M•1400i. A built- in delay circuit saves your speakers (and ears) from the thumps or pops that can sometimes occur when powering up a system. During this 3 second delay, the PROTECT LEDs light up. 2. A short circuit (or near short) in either of the outputs. Both the PROTECT and the SHORT LEDs light up. 3. The temperature in the M•1400/M•1400i has risen to an unsafe level. The PROTECT and the TEMP STATUS HOT LEDs light up. The M•1400/M•1400i amp draws its ventilation air in from the front and out through the side panels. The amp needs plenty of fresh air to stay cool. DO NOT BLOCK THE VENTILATION PORTS. See "Thermal Considerations" on page 23 for more details. SHORT If this LED comes on, the M•1400/M•1400i has detected a short circuit in either of the outputs, meaning that the hot (+) and cold (-) speaker wires are touching, or a speaker itself is shorted out. Such a condition causes the M•1400/M•1400i to engage its PROTECT mode (when a signal is present), muting all signals at the amp's outputs. This short-circuit LED is a Mackie exclusive (until the other guys "borrow" the idea) and can save precious minutes of your troubleshooting time. Without it, you'd still have speaker and amp protection (via the PROTECT circuit), but you wouldn't be able to determine the source of the problem. But with the SHORT LED, the M•1400/M•1400i comes right out and tells you! WARNING: The SHORT LEDs indicate an unsafe condition for the power amplifier. When the short-circuit protection is activated, the SHORT LED lights, then the PROTECT LED lights and the SHORT LED turns off. After about four seconds, the protection circuit turns off and the amplifier resumes normal operation. If it senses the shorted condition again, the cycle repeats until you fix the problem. Typical causes for a "short" indication would be either a shorted speaker cable or too many speaker cabinets connected to the amplifier (i.e., the load impedance is too low). If a "short" is indicated, please check your cables. If the cabling is OK, then reduce the number of cabinets driven by the amplifier. Note: When using the amplifier in BRIDGE mode, one or both SHORT LEDs may light under shorted or low impedance conditions. Regardless of whether one or both LEDs light, it's an indication of a problem that requires further investigation. PROFESSIONAL POWER AMPLIFIER ON OFF POWER 13