Magnavox ZV450MW8 Owners Manual - Page 22

CHANNEL SETTING If you have changed antenna connection, we recommend that you program available channels in your area with the following procedures. Auto Channel Scan STANDBY-ON SOURCE DTV/TV DISPLAY OPEN/CLOSE A .@/: 1 GHI 4 PQRS 7 . ABC 2 JKL 5 TUV 8 SPACE 0 DEF 3 MNO 6 WXYZ 9 CLEAR DISC MENU o SETUP s OK B TITLE RETURN p j B i F h g C CHANNEL -- + REC MODE VCR DVD TIMER REC AUDIO I TIMER CM SKIP D.DUBBING SET RAPID PLAY SEARCH 1 Press [SETUP]. 2 Use [K / L] to select "Channel", then press [OK]. "Channel" menu will appear. 3 Use [K / L] to select "Auto Channel Preset", then press [OK]. 4 Use [K / L] to select the type of broadcasting signal, then press [OK]. Auto Channel Preset VCR DVD Antenna Cable (Analog) Cable (Analog / Digital) The unit will start getting channels available in your area. • When aerial antenna is connected, select "Antenna". • When connected to CATV, select "Cable (Analog)" or "Cable (Analog/Digital)". To cancel the auto channel preset during scanning: Press [RETURN] or [SETUP] to cancel. 5 When scanning is over, press [SETUP] to exit. To cycle through only the memorized channels, use [CHANNEL / ]. To select a channel directly (including the ones not memorized), use [the Number buttons]. Note • If the auto channel preset is canceled during presetting, some channels not yet preset may not be received. • The selection will depend on how you receive the TV channels. • You cannot change the channel when either VCR or DVD is in any recording mode (basic recording, onetouch timer recording or timer recording). 22 EN