Magnavox ZV450MW8 Owners Manual - Page 39

Introduction Connections Basic Setup Recording TIMER RECORDING Checking, canceling, or correcting the timer programming information 1) Press [TIMER SET]. If the timer program did not complete correctly, the error number appears in the timer programming list. 2) Press [TIMER]. 3) Check the information on the list you will need. Timer Programming Date Start End CH 1. JAN/01 12:57AM 1:57PM 8 2. --- 3. --- 4. --- 5. --- 6. --- 7. --- 8. --- VCR DVD DVD VCR Mode DVD HQ 4) To clear the timer programming: Use [K / L] to select the program, then press [CLEAR]. To correct the timer programming: Use [K / L] to select your desired program, then press [OK]. Next, correct the timer programming by using [K / L / { / B]. Finally, press [OK] again. 5) Press [TIMER] to exit. 6) Press [TIMER SET] to return to the timer standby mode. To stop the timer recording in process Press [STOP C] to stop the disc recording or [STOP C/EJECT A] to stop the cassette tape recording on the front panel of the unit. [STOP C] on the remote control is not effective. Note • Press [TIMER] to check the timer recording in progress. When the timer recording is proceeding, that program will be highlighted with red. In this case, you cannot select any other program. Timer Programming Date Start End CH * JAN/01 12:57AM 1:57PM 8 2. --- 3. --- 4. --- 5. --- 6. --- 7. --- 8. --- VCR DVD DVD VCR Mode DVD E22 Press [CLEAR] to erase the selected program. Each error number means: E1-22 Recording error other E41 E37-39 than below E24 Unrecordable disc E42 E25-26 Copy prohibited E43 program E29 Disc protected E44 E30 Disc full E45 E35 PCA full E46 E36 Already finalized video format disc E40 Some portion has not been recorded because of program overlapping. Recording did not start at the start time. Power failed No disc when recording Already 49 titles recorded Already 254 chapters recorded Copy prohibited program It is impossible to record additionally on a disc recorded by other units when setting "Replace Disc Menu" to "OFF". • E23, E27, E28, E31, E32, E33 and E34 are not displayed. • A program with the error number is grayed and asterisked in the timer programming list. • Once the timer programming list with error line(s) is displayed, or after canceling and setting again the timer standby mode, the program line(s) with error will be cleared. Playback Editing Function Setup VCR Functions Others Español EN 39