Makita RJ01W Technical Reference - Page 12
Switch trigger side, Housing L, Housing R side, Terminal
View all Makita RJ01W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Wiring diagram (cont.) Fig. D-3 Wiring to DC Motor Assemble DC Motor to Housing (L), * the Lead wires must be faced to Housing (R) side. * the Lead wire (black) must be located to the Switch trigger side. P 12/ 12 Fig. D-4 Wiring to Terminal Connect the Lead wires to Terminal as drawn below. Housing L side 30 degrees Red point mark Housing R side Terminal Switch trigger side Bend the Terminal with black Lead wire 30 degrees toward the center so that the Terminal does not touch the rib for setting DC Motor. Now, Switch can be mounted to Housing (L) as drawn in Fig. D-5. Fig. D-5 Wiring of Lead wires of DC Motor, Switch, Terminal in Housing (L) Pass the Lead wires (black, red) between DC motor and Switch through Line filter when it is used. And put the Line filter to this place. Housing (L) Line filter location when it is used. Bend Terminal of DC motor inside so as to be stored between Rib C and Rib D. Rib C Route Lead wires (white, black) from connector to this place and store them in this place. DC Motor Switch Rib D Switch trigger Store Switch lead wire (red) to Terminal within the Terminal's width designated with dotted lines. Lead wire (red)