Netgear DM111Pv2 DM111Pv2 Setup Manual - Page 12

Computers Set to DHCP For the initial connection to your router, your computer has to be set to automatically get its TCP/IP configuration from the router via DHCP. This is usually the case. The NETGEAR Smart Wizard CD automatically takes care of this requirement. For manual setup, refer to the documentation that came with your computer. Manually Setting Up Your Modem Router There are four steps to setting up your modem router: 1. Install ADSL filters on the phone lines. 2. Connect the modem router to the ADSL line. 3. Log in to the modem router. 4. Connect to the Internet. Follow the steps below to connect your router to your network. Before you begin, locate the ADSL configuration information from your Internet Service Provider (ISP). 1. Connect the ADSL filter. If you purchased the modem router in a country where an ADSL filter is not included, you must acquire one. a. You need to install an ADSL filter for every telephone that uses the same phone line as your modem router. Select the filter that came with your modem router. 1 2 3 1. One-Line Filter: Use with a phone or fax machine. 2. Splitter: Use with a one-line filter to share an outlet with a phone and the modem router. 3. Two-Line Filter with Splitter: Use to share an outlet with a phone and the modem router. Figure 6 8 Connecting the Router to the Internet