Netgear DM111Pv2 DM111Pv2 Setup Manual - Page 23

Restoring the Default Configuration and Password, Using the Reset Button

Get Netgear DM111Pv2 - ADSL2+ Ethernet Modem PDF manuals and user guides View all Netgear DM111Pv2 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 23 highlights

Restoring the Default Configuration and Password This section explains how to restore the factory default configuration settings, changing the router's administration password to password and the IP address to 192.168.0.1. You can erase the current configuration and restore factory defaults in two ways: • Use the Erase function of the Web Management Interface. • Use the Default Reset button on the rear panel of the router. Use this method for cases when the administration password or IP address is not known. Using the Reset Button To restore the factory default configuration settings without knowing the administration password or IP address, you must use the Default Reset button on the rear panel of the router. 1. Press and hold the default reset button until the Power LED turns red (about 10 seconds). 2. Release the Default Reset button and wait for the router to reboot. Troubleshooting 19

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
Troubleshooting
19
Restoring the Default Configuration and Password
This section explains how to restore the factory default configuration settings, changing the
router’s administration password to
password
and the IP address to 192.168.0.1. You can erase the
current configuration and restore factory defaults in two ways:
•
Use the Erase function of the Web Management Interface.
•
Use the Default Reset button on the rear panel of the router. Use this method for cases when
the administration password or IP address is not known.
Using the Reset Button
To restore the factory default configuration settings without knowing the administration password
or IP address, you must use the Default Reset button on the rear panel of the router.
1.
Press and hold the default reset button until the Power LED turns red (about 10 seconds).
2.
Release the Default Reset button and wait for the router to reboot.