Netgear FSM726 FSM726v2 Setup Manual - Page 32
Main Menu> Advanced> Port Mirroring
UPC - 606449026856
View all Netgear FSM726 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
700 Series Software Manual v2.1 • Spanning Tree: Spanning Tree Protocol (STP) ensures that only one path at a time is active between any two network nodes. There are maybe more than two physical path between any two nodes for redundant paths; STP ensures only one physical path is active and the others are blocked. STP will prevent an inadvertent loop in a network, which can disable your network due to a "Broadcast storm", the result of a broadcast message traveling through the loop again and again. • MAC: MAC address table. This menu allows you to set the aging time, as well as entering static MAC addresses to the switch. • Multimedia Support (IGMP): The Internet Group Management Protocol (IGMP) is an Internet protocol that provides a way for network devices to report multicast group membership to adjacent routers. • SNMP: You can use an SNMP-based Network Management Software program to manage your switch. This menu allows you to set up the appropriate tables to enable the switch to respond to SNMP queries. • Command Line: A user interface that allows you to configure the switch via a command line interface. See Chapter 6 for information about the Command Line Interface (CLI) Main Menu> Advanced> Port Mirroring This menu option allows you to enable the Port Mirroring capability. You need to specify both the Source and Monitor port. Figure 4-16: Port Mirroring The Monitor port will show a copy of every packet that arrives and departs at the Source port. 4-14 Administration Console Telnet Interface