Netgear FSM726 FSM726v2 Setup Manual - Page 64
Set-up> Port Configuration
UPC - 606449026856
View all Netgear FSM726 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
700 Series Software Manual v2.1 Click Apply to change the IP settings Save Configuration to NVRAM and reset the system to implement the changes (Tools > Save Configuration). Set-up> Port Configuration Figure 5-14: Port Configuration This menu allows you can configure the status of each port. • Port: The port number on the switch • Name: The name of the port. This is a user-defined label. • Link: A green triangle pointing up indicates a valid link, while a red triangle pointing down indicates no link. • On/Off: Indicates if the port is enabled or disabled by the Administrator. • State: This refers to the Spanning Tree state of the port. Ports will be Blocking (Blk), Listening (Lis), Learning (Lrn), Forwarding (Fwd) or Disabled (Dis). • Speed: Indicates the speed and duplex for the port. The possible entries are Auto-negotiation (Auto); 10 Mbps half duplex (10M Half); 10 Mbps full duplex (10M Full); 100 Mbps half duplex (100M Half); or 100 Mbps full duplex (100M Full). 5-14 Web-Based Management Interface