Netgear FVX538v1 FVX538 Reference Manual - Page 22
Router Front and Rear Panels, Table 1-1., Object Descriptions
View all Netgear FVX538v1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
ProSafe VPN Firewall 200 FVX538 Reference Manual Router Front and Rear Panels The ProSafe VPN Firewall 200 front panel shown below contains the port connections, status LEDs, and the factory defaults reset button. 1 2 3 4 5 6 7 Figure 1-1 Table 1-1 describes each item on the front panel and its operation. Table 1-1. Object Descriptions Object Activity Description 1. Power LED On (Green) Off Power is supplied to the firewall. Power is not supplied to the firewall. 2. Test LED On (Amber) Blinking (Amber) Off Test mode: The system is initializing or the initialization has failed. Writing to Flash memory (during upgrading or resetting to defaults). The system has booted successfully. 3. WAN Ports and LEDs Two RJ-45 WAN ports N-way automatic speed negotiation, Auto MDI/MDIX. Link/Act LED On (Green) Blinking (Green) Off The WAN port has detected a link with a connected Ethernet device. Data is being transmitted or received by the WAN port. The WAN port has no link. 100 LED On (Green) Off The WAN port is operating at 100 Mbps. The WAN port is operating at 10 Mbps. Active LED On (Green) On (Amber) Off The WAN port has a valid Internet connection. The Internet connection is down or not being used because the port is available for failover in case the connection on other WAN port fails. The WAN port is either not enabled or has no link. 1-6 Introduction v1.0, March 2009